Super-micro-computer I2DMR-8G2 Manuel d'utilisateur télécharger pdf (Page 28)

2-8

SUPER i2DMR-8G2/i2DMR-iG2 User's Manual

F. Installing the Heatsink on the CPU(*for CPU w/o Heatsink

only)

(*Warning: Do not apply any thermal grease to the heatsink-the required

amount of thermal grease has already been applied.)

1. Place the heatsink (P/N SKT-0046) on top of the CPU so that the four

mounting holes are aligned with those on the retention mechanism as

shown in Figure 1 below.

2. Screw in two diagonal screws (ie the #1 and #2 screws) until just

snug (do not fully tighten), then do the same with the remaining diagonal

screws as shown in Figure 2 and Figure 3.

1) Locate the four mounting holes on

the heatsink retention module.

Figure 1

Figure 2

Figure 3

(*Note: To maximizing the cooling effect of the i2DMR-8G2/iG2, we

strongly recommend that Supermicro's proprietary heatsinks (SNK-046)

be used with the Itanium 2 CPUs.)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 77 78

Pas de commentaire

Super-micro-computer I2DMR-8G2 Manuel d'utilisateur Page 28